f.
Select a clean, convenient mounting location on a wall beneath
the sink, allowing sufficient space for placement of the FMU. Peel
off the paper backing from the second hook-and-loop connector
strip and attach it to the desired wall location.
g.
Attach the FMU to the wall using the two hook-and-loop connector
strips.
4.
Prepare the Filter Monitor Unit
a.
Attach the two filter monitor adapters (#15) to the FMU (#14), one
on each side.
b.
Complete the installation after connecting the tubing.
5.
Connect the Tubing from the Housing to the Filter Monitor Unit
NOTE:
Complete this step only after
the CB-As tubing has been connected
in section
Connect the Tubing to the
Housing (Pg 14)
.
a.
Fully insert the blue plastic tubing
from the CB-As OUTLET into the
adapter (#15) on the INLET (#5)
side of the FMU; the tubing should
typically be inserted 5/8” into the
adapter. The inlet side is the side
from which the arrow points away
on the capacity flow device.
NOTE:
When pushing the tubing
into the adapter, you will encounter
some resistance. This does not
mean that the tube is fully inserted.
Continue to push firmly until the
tubing is inserted as far as possible
(roughly 5/8” into the adapter).
6.
Connect the Tubing from the Faucet to the Filter Monitor Unit
a.
Fully insert the blue plastic tubing from the faucet into the adapter
(#15) on the OUTLET (#5) side of the FMU; the tubing should typically
10
5
5
OUTLET
to faucet
tubing
adapter
OUTLET
Pull to check that the tubing is secure.
Insert tubing and push until you feel
resistance - at this point, the tubing is not
fully inserted. Push firmly until the tubing
is inserted as far as it will go.
INLET
to housing
insert
14
5
