Cattron Messenger W, Руководство пользователя

Страница: 9 / 19

Messenger W
User Manual
9
9M02-7000-A001-EN
Version A
3 LED States
There are eight LEDs used to indicate various system conditions. The locations of these LEDs can be seen in
Figure 2 in the Diagrams section. Specific information is conveyed to the user via LED blink patterns. On power-
up, an LED test is performed by blinking all LEDs every second for 3 seconds. Following the LED test, the LEDs
blink based on the following conditions.
LED 1 (GRN) – System
State Rate Definition
Blink 1 blink every 5 seconds Sleep Mode
Blink 1 blink every second CPU Run – Normal
Blink 5 blinks every second Boot Loader Mode (all other LEDs off)
On or Off Solid System Failure
LED 2 (RED) – Cell Registration
State Rate Definition
Blink Rapid blink, then off OK – Rx/Tx Activity with CELL Modem
Blink 1 blink every second Not Registered
Check APN
Verify valid cellular account
Off Solid OK – Registered
LED 3 (RED) – Cell Status
State Rate Definition
Blink 10 blinks every second No SIM card or communications failure with modem
On Solid Not Ready/Fault
Blink 1 blink every second Error
Off Solid OK
LED 4 (RED) – CAN
State Rate Definition
On Solid Fault, no engine bus activity detected
Blink 2 blinks every second OBD traffic detected, but no response to data queries
Blink 1 blink every second Engine bus not selected, check DIP Switch 2
Off Solid No Faults, engine bus activity detected