Cattron-Theimeg CT24 Excalibur, Руководство по эксплуатации

Страница: 20 / 25

Edition 04/2007 US, Version A001, Excalibur, Subject to Technical Changes Page: 17
B-1 Fault Messages of the Transmitter
Fault indications Status LED Action
TransKey cannot be read 2 flashes Plug in the TransKey
Fault in the TransKey configuration 3 flashes Have the TransKey configuration checked
by Cattron-Theimeg
Fault in the low-voltage test 4 flashes Replace transmitter pcb
Switch-on sequence not performed
correctly
5 flashes Switch the transmitter off and then on
again
Fault during reading of command
initiator
6 flashes Replace transmitter pcb / keyboard
Incorrect HF module or HF module
incorrectly configured
7 flashes Replace HF module
General system fault 8 flashes Replace transmitter pcb
Too quick low -voltage after the
switch-on
9 flashes Replace/charge battery
Hardware fault 10 flashes Replace transmitter pcb
B-2 Fault Messages of the Receiver
Status indications Fault indication
LED
Action
TransKey cannot be read 2 flashes Plug in the TransKey.
TransKey cannot be read 3 flashes Plug in the correct receiver TransKey
Fault in the low-voltage test during
switch-on
4 flashes Replace the pcb
K0 relay fault 5 flashes Check the K0 relay
Fault during reading of the relay
contacts
6 flashes Replace the relay pcb
Incorrect HF module or HF module
incorrectly configured
7 flashes Replace the HF module or correct the
configuration
General system fault 8 flashes Replace the pcb
Low -voltage condition of the power
supply detected
9 flashes —
Fault detected by 2nd processor 10 flashes —