Getting Started
your unit, as required.
3.3 How to Power Up the Unit
To power up the unit(s):
With all signal and power cables connected as required, through equipment power supply. Wait
for unit to initialize completely.
3.4 How to Set the Unit IP Address
Setting the IP address of a unit is accomplished using the front panel menus. For a full description
of these menus, see
Chapter 4, Front Panel Control
.
To set the IP address of the unit(s):
1.
Ensure the unit is fully powered up.
2.
On the OLED front panel, using the touch button, go to the
IVP-3000 Frame>IP Setting
option.
3.
Press
Enter
Button to select.
4.
Using the touch button, set the IP address, subnet mask and gateway address.
5.
Press the
Enter
button to save or
Esc
to discard the changes.
Note:1. It may be necessary to set the IP address, gateway address and Virtual IP address to 0, and to set
a subnet mask in order to allow the IP address to be changed.
2.IP Addresses on the unit must adhere to RFC3330 range of restrictions as listed in the following
table of allocated IP addresses.
3.Make sure that the control network and data networks do not conflict.
3.5 How to Configure Ethernet Control Port
The Base Chassis has control port that support IEEE 802.3 100 BaseTX and 1000 BaseT
protocols.
Figure 3.2 Control Port
