Getting Started
Chapter 3 Getting Started
3.1 Introduction
Due to the number of different ways the IVP-3000 Series can be used, it is impossible to give
precise setting up instructions for every possible working scenario. This chapter, therefore, gives
general guidance and principles on how to power up and set up your unit for operation and
describes the more common operations you will want to perform.
For details of all Front Panel menus and controls, see
Chapter 4, Front Panel Control.
For details
of all Web Graphical User Interface menus and controls, see
Chapter 5, Web Control
.
3.2 How to Connect Up the Unit
See Chapter 2, installing the Equipment for all connector details.
Figure 3.1 Equipment Connection Diagram
To connect up the unit(s):
Connect signal input connectors (for your input Transport Streams) to your local area network if
IP/ASI inputs are to be used.
Connect signal output connectors (for your output Transport Streams) to your local area network
if IP/ASI outputs are to be used.
Connect computer control connectors Web Control to your local area network. Both connectors
are in the same subnet mask.
Connect single or dual AC power connectors, depending on the option purchased, to the power
supply.
Connect your signal cables to/from your option cards, depending on which options are fitted to
