Cathode Corner SCTV, Инструкция по сборке и эксплуатации

Страница: 24 / 34

SCTV Clock Assembly Manual 1/24/22 24
The small end of the CRT is held in place with the clamp ring, which is bolted to the outside of the rear
face. The 3/8" screws hold the clamp to the face, and the ¾” screw clamps the CRT neck in the metal
ring. Assemble the CRT neck components in the following order:
The CRT neck clamp must be spread apart from its factory shape. Bend it evenly with your fingers to a
larger diameter, so that there is 1/2" gap where the clamp screw goes. Now bend the two clamping tabs
towards each other slightly with slip-joint pliers so that they are parallel to each other. Bend each of the
two screw tabs and the other two tabs so they are perpendicular to the metal, so that they all lie flat on a
table.
Install the 6-32x3/4" screw and nut into the clamping holes so that the nut is on the side closest to one of
the screw tabs. Only thread the nut on a few turns, as the clamp needs to be loose.
While holding the CRT wires in the notch on the side of the rear face hole, hold the clamp ring to the
rear face with the clamping screw towards the bottom. Install a 6-32x3/8" screw into the top clamp hole
and through the rear face. Install a 6-32 hex nut on the screw inside the rear face. Repeat for the other
clamp screw. See the photo below. Tighten these screws firmly while holding the clamp ring centered in
the opening.