ENGLISH JULY 2020 - IND B
Page
23
of
162
CATANA SAS - Zone Technique du Port - 66140 CANET EN ROUSSILLON (FRANCE)
e - mail: [email protected] - Tel +33 (0)4 68 80 13 13 - Fax +33 (0)4 68 80 13 19
4. GAS INSTALLATION
(Plans on pages N°119 to N°120)
4.1 Instructions for use
Your Bali CS is fitted with a gas installation. Depending on the type of gas used on board (butane or propane),
the pressure in the circuit will be between 28mbar and 37mbar. Consequently, before any work is carried out
on the gas circuit or cooking appliances (hob, barbecue grill, etc.) the compatibility of the components: gas
bottle, jets, regulator). The operating pressure will always be shown on the regulator.
-
Ensure that the gas bottle conforms to the regulations in force in the country where you are using
it.
-
Do not obstruct quick access to gas installation (gas bottle locker, shut-off valve).
-
The gas bottle must always be placed in the waterproof and ventilated housing designed for this
purpose (Figure 4). The same goes for spare or empty bottles. No other equipment should be
stored in this area.
-
The valves attached to empty bottles must be closed and disconnected. Protective tops, covers,
or plugs must be kept in place. Spare cylinders must be stored in housings or lockers designed for
LPG cylinders which vent overboard, or stored outside on the vessel, protected from weather and
mechanical damage and such that any escaping gases can only evacuate overboard.
The gas locker is located in the
aft bench seat, to starboard. The
spare gas bottle is located
symmetrically opposite, to port.
Figure 4
