17
To Get Started Using the Hot Swapping Software
At Power Up
Before the software in this package can be used, the following steps must be performed:
1.
Power Down the Computer, remove the cover, and install the PCI Extender in a PCI Slot.
2.
Install the UUT on top of the extender and be sure that the On -Off switch on the extender is in the On position.
3.
Power on the computer and allow the system to go through boot.
4.
When the computer has finished booting, verify that the UUT is working properly by executing your application.
5.
If the UUT is working properly, you can proceed using the software provided in this package, please see the
section on Operating Instructions for PCIUW or PCIUD.
6.
If the UUT is not working properly, refer to the troubleshooting guide section of this document.
NOTE:
Please note that the utility programs provided here only read and write the configuration space data
to UUT and do not actually assign these parameters.
On system power up the BIOS has to do the assignment and initialization of the configuration
registers before the utility programs may be used.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
