Cata TDG 3002 BK, Инструкции по установке, использованию и обслуживанию

Страница: 20 / 83

For 5 seconds the timer display remains at “0“ before it will be
switched-off.
Timer programming on cooking zones
When the control is switched ON, an independent timer can be
programmed for every cooking zone.
To use the cut off timer, make sure the control is ON, selecting the
cooking zone and the zone LED display blinks, pressing button (9)
and timer display shows “--”.
Adjustment range (0-99min), it can be set in 1-minute steps with
MINUS (2) and PLUS (3). after setting minutes, press button (9)
again to set dozens of minutes. Then wait for 5 seconds the timer
on independent zone is activated.
During timer programming, a red dot (7) next to pilot light (6) of
the selected cooking zone flashes to indicate the zone is under
timer status.
When the timer has run down, there is a sound signal and the tim-
er display shows “--“ statically.. The pro-grammed cooking zone
will be cut off and “H“ will be displayed if the cooking zone which
is hot, otherwise a stroke will show in the cooking zone display.
The sound signal and the blinking of the timer LED will be stopped
automatically after 10 sounds and the timer display extinguishes.
The basic behaviour follows the description of the “mi-nute mind-
er” (stand-alone-timer).
Maintenance (Fig. 4)
By means of a scraper immediately remove any aluminum foil
bits, food spills, grease splashes, sugar marks and other high
sugar content food from the surface in order to avoid damaging
the hob.
Subsequently clean the surface with some towel and appropriate
product, rinse with water and dry by means of a clean cloth. Un-
der no circumstance should sponges or abrasive cloths be used;
also avoid using aggressive chemi-cal detergents such as oven
sprays and spot removers.
Installer’s Instructions
Installation
These Instructions are for the qualified technician, as a guide to
installation, adjustment and maintenance, accord-ing to the laws
and standards in force. These operations must always be carried
out when the appliance has been disconnected from the electric
system.
Positioning (Fig. 5)
1 Front view
2 Front side
The appliance can be fitted into a working area as illus-trated on
the figure. Apply the seal supplied over the whole perimeter of
the working area.
Electrical connection
Prior to carrying out the electrical connection, please ensure that:
the plant characteristics are such as to follow what is indicated
on the matrix plate placed at the bottom of the working area;
- that the plant is fitted with an efficient earth connection, follow-
ing the standards and law provisions in force.
- The earth connection is compulsory in terms of the law.
Should there be no cable and/or plug on the equipment, use suit-
able absorption material for the working tempera-ture as well, as
indicated on the matrix plate. Under no circumstance must the
cable reach a temperature above 50°C of the ambient temperature.