CASTLE 1700 iD Alarm, Руководство по эксплуатации, Страница: 8 / 22

2 Using the System
2.1 Setting the System
2.1.1 Setting the System with the Keypad
Step Action Response Display
a Verify that all doors, etc. are closed,
and that '
d
' is displayed
'
d
'
b Enter your 4-digit code, followed by # if
the system is to be FULL set, or * if to
be PART ('B') set. Acceptance of code will be
confirmed by display showing a
single 'bar' (flashing if PART
set). After a few seconds, a
steady tone will commence. '
-
'
(flashing if
PART set)
c Leave the building by the specified
route.
To set the system silently (eg at night if
part of the family is asleep): press *
within 2 seconds of completing step b. Continuous tone sounds.
Tone will be aborted.
'
-
'
(flashing if
PART set)
d If a detector is in fault condition, eg a
door is opened
If this detector is part of the exit route,
you may continue, ensuring that all
doors are closed behind you; otherwise
correct the fault before attempting to
leave the building The tone will become
intermittent
When closed, the tone will
become steady once more. The display
will indicate
the number
of a
detection
zone in fault
condition
e Close the Final exit door Tone will cease when timer
expires '.'
f When door is fully secure, press 'Push
to Set' button (if fitted) Tone will cease immediately
g The system may be programmed for the external strobe to flash briefly to
confirm that the system is set.
h If the tone does not cease at the pre-set
time A fault exists, re-enter the
building, switch off the alarm
and correct the fault before
trying again.
1700 Alarm System (7S) Operating Instructions
January 2000 Page 7