Freestanding Assembly Instructions
The heater must always be used in the upright position. When using as a freestanding, do not operate
without the feet in place.
1.
Ensure the heater is unplugged and power is switched off.
2.
Set the heater upside down, and get the 3 x ST4*12 Screws and feet ready.
3.
Locate the 3 x screw holes at each end of the
heater base.
4.
Place the screws in the hole and twist the screws
accordingly to position to secure each feet.
5.
Turn the unit upside down again to an upright
position, and place it on the floor after assembling.
The heater is now ready for use.
Wall Mounting Assembling Instructions
WARNING:
The appliance must be installed at least 1
0
cm from the ground and 50cm away from the
ceiling when wall-mounted.
WARNING:
Ensure there are no electrical cables or pipes behind the point in which you are drilling the
holes.
1.
Ensure the heater is unplugged and power is switched off.
2.
The distances between the two wall mounted brackets are 335mm (NR10), 370mm (NR15),
515mm (NR20). Check the assembly will be horizontal with a spirit level.
3.
With a diameter of 8mm and depth of 40mm, insert the supplied anchors in the holes. Then use
a screwdriver to tighten in the screws supplied with anchors. The screws must protrude 6mm
from the anchor.
4.
After positioning the screws into the unit, hang the hook holes on the back of the unit.
