Casolin 530 DIGIR, Инструкция по эксплуатации, Страница: 33 / 39

10/97 M42.02.34.0 PAG. 34
MAINTENANCE OF 530 DIGIT (430 DIGIT) SURFACE PLANING
TROUBLE-SHOOTING
CAUSES SOLUTIONS
Emergency button pressed. Release the emergency button(s) by turning these.
No power supply on one or more of the line
phases. Make sure that the voltage of the workshop power supply
is present on all three phases.
*
Fuses blown; or fuse caps loose.
Check the state of the fuses using a tester and replace
these if necessary.
Overload cut-out thermal relay not activated. Re-activate by pressing the blue or grey RESET button of
the thermal relay situated inside the electric control panel.
Brake release switch activated: orange warning
light illuminated. De-activate the switch by turning the lever anticlockwise,
into start position.
Problem: THE MACHINE STOPS DURING PLANING
CAUSES SOLUTIONS
Overload cut-out thermal relay not activated. Re-activate by pressing the blue or grey RESET button of
the thermal relay situated inside the electric control panel.
No power supply on one or more of the line
phases. Make sure that the voltage of the workshop power supply
is present on all three phases.
CAUSES SOLUTIONS
*
Loose belts.
Tighten the belts (page 31).
Knives not sharp enough or badly sharpened. Re-sharpen the knives carefully.
CAUSES SOLUTIONS
Delivery table. Adjust the delivery table to the same height as the knife
(Page 22).
CAUSES SOLUTIONS
Delivery table. Make sure that long workpieces are supported by table
extensions or supports.
Problem: THE MACHINE DOES NOT START
Problem: POOR MOTOR PERFORMANCE
Problem: INCORRECT WORKPIECE
PARALLELISM
Problem: RIDGE ON THE DELIVERED
WORKPIECE