CASO DESIGN MIG25 Ceramic, Оригинальное руководство по эксплуатации

Страница: 50 / 180

50
11.7 Unpacking
To unpack the device, proceed as follows:

Remove the device out of the carton and remove the packaging material.

Remove the accessories located in the cooking chamber and remove the packaging
material.
Please note
► Please don’t remove the protective film from the inside of the door (if equipped), since
this makes the cleaning of the device easier.
11.8 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and
reduces the quantities of accumulated waste. Take any packaging materials that
are no longer required to “Green Dot” recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.
11.9 Setup
11.9.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:

The device must be set up on a firm, flat, horizontal and heat-resistant surface with
sufficient load-bearing capacity for the oven and the maximum weight of the expected
food that is to be prepared in the oven.

Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.

The device is not intended to be installed in a wall or a built-in cupboard.

Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.

The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 20 cm above the oven, 10 cm around the back and 5 cm on both sides.

Do not cover up any openings on the device and do not block these off.

Do not remove the device’s adjustable feet.

The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.