Casio QT-8000, Руководство по обслуживанию

Страница: 41 / 74

- 39 -
SUPER IO DEVICE:
The options for these items are found in its sub menu. By pressing the <ENTER> key,
you are prompt to enter the sub menu of the detailed options as shown below:
Phoenix – Award CMOS Setup Utility
SuperIO Device
Item Help
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Serial Port 3
Serial Port 3 Use IRQ
Onboard Serial Port 4
Serial Port 4 Use IRQ
Onboard Parallel Port
Parallel Port Mode
X EPP Mode Select
X ECP Mode Use DMA
[3F8/IRQ4]
[2F8/IRQ3]
[3E8]
[IRQ10]
[2E8]
[IRQ11]
[378/IRQ7]
[SPP]
EPP1.7
3
Menu Level
„
↑↓→←
:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Descriptions on each item above are as follows:
1. Onboard FDC Controller
Select Enabled if the system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install and-in FDC or the system has no
floppy drive, select Disabled.
2. Onboard Serial Port 1/2/3/4
Select an address and corresponding interrupt for the first and second serial ports.
3. Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with which
I/O address.