E-14
Part 7 Confi guring the Printer Setup
The printer has a SET UP screen that you can use to confi gure the display
contrast and the print density setting.
To confi gure the printer setup
1. Press
.
2. Use and to select
(display contrast) or
(print density), and
then press
.
3. Use the cursor keys to change the setting of the currently selected setup
item.
When this setup
item is selected:
Use these cursor keys
to change the setting:
Display contrast
and
Print density
and
4. After the settings are the way you want, press
to apply them.
Part 8 Reference
User Maintenance
Print quality will suffer if the printer head and/or rubber roller become dirty. A
dirty tape cutter will result in poor cutting performance. Periodically perform
the user maintenance steps below to clean the printer head, rubber roller, and
tape cutter.
Important!
Use a cotton swab or some other similar soft object to clean the printer head,
rubber roller, and tape cutter. Use of an ultra thin swab is recommended.
To clean printer components
1. Perform step 1 on page E-6 to open the tape compartment cover.
x
If there is tape loaded in the printer, remove it.
Important!
The printer head is hot during and immediately after printing. Be sure to allow
enough time for it to cool before removing the tape.
2. Moisten the swab with alcohol and then use it to wipe the printer head,
rubber roller, and tape cutter surfaces. At this time, do not directly touch
the tape cutter. Touching the cutter can cause fi nger cuts.
Take particular care when wiping the
contact areas of the roller and printer
head.
Tape cutter
Printer head
Rubber roller
