88
Using Two Cameras at the Same Time (Multi
Camera Mode)
NOTE
• Up to two cameras can be registered at one time. To add a new camera while two
cameras are already registered, you will need to first unregister one of the
registered cameras.
• A message will appear if camera registration fails, and then the display will return to
the screen that was shown before you touched the “
¥
Setup” tab. If this happens,
perform the camera registration procedure again from step 1.
• You can also use the procedure below to register a camera on a controller.
If the camera has a memory card loaded, remove it.
While holding down the camera shutter button, hold down the [
p
] (Power)
button for at least one second.
While holding down the controller shutter button, hold down the [
p
] (Power)
button for at least six seconds.
This will cause the operation lamps of the camera and the controller to flash
orange to indicate that camera registration has started.
.
To unregister a camera
1.
Turn on the controller and one of the cameras.
This will establish a connection between the controller and camera you turned on.
2.
On the menu screen, touch the “
¥
Setup” tab.
3.
Touch “Multi-Pairing”.
4.
Touch “Unpair”.
The names of the cameras registered on the controller will appear on the display
in sequence.
5.
Touch the name of the camera you want to unregister.
6.
Touch “Yes”.
The camera you selected will be unregistered and then the display will return to
the screen that was shown before you touched the “
¥
Setup” tab.
A message will appear if the camera you select is connected to the controller. If
this happens, touch “Yes” to unregister.
NOTE
• You cannot unregister either camera while two cameras are connected to a single
controller (Multi Camera Mode). In this case, you need to turn off either of the
cameras, and then perform the procedure above to unregister.
