Terminal Setup
Connecting the Cradle
The terminal download requires a serial connection between the terminal and the PC
through a cradle. Connect the serial load cable from a serial port on the PC to the
communications port of the terminal cradle or to a Casio terminal.
In preparation for this download perform the following:
•
Make sure you have copied the LMWIN utility to
any
directory on your PC.
•
Connect the selected serial port on the PC to the cradle with a null modem cable. Use
COM Port 1.
•
Verify that the cradle is powered on.
•
If you are using a cradle, configure the cradle baud rate to 115200.
•
Set the dip switches on the bottom of the cradle. There are ten switches. The
up
position of a switch is the
on
position. The settings for the ten switches are shown
below to set the cradle baud rate to 115200.
Switch
1 2 3 4 5 6 7 8 9 10
Setting
On Off Off Off On Off On On On On
When using a cable, the baud rate to select is also 115200.
Terminal Settings
Command Mode Boot
On the portable terminal, power the terminal
OFF
, then boot the terminal using the key
sequence as shown in the following table.
Command Mode Boot Sequences
Following Power
OFF
Terminal Model & Keypad
Key Sequence
DT-800RF
Press the
FNC
and
0
keys,
then press and release the
PWR
key,
then release the
FNC
and
0
keys.
The System Menu is displayed.
SYSTEM MENU
1. EXECUTE AP
2. SET MODE
3. DATE/TIME
4. TRANSMIT
5. CALIBRATION
6. VERSION
7. SS UTILITY
1. Select
7: SS Utility
and
then
1: Environment
.
2. Enter the IP Address, Netmask, Gateway, Domain, etc.
Supported Equipment Manual
•
March, 2006
2-10
