Operation Guide 2894
9
Important!
•
Storing the watch for long periods in an area where there is no light or
wearing it in such a way that it is blocked from exposure to light can cause
rechargeable battery power to run down. Be sure that the watch is normally
exposed to bright light whenever possible.
•
This watch uses a special rechargeable battery to store power produced by
the solar cell, so regular battery replacement is not required. However, after
very long use, the rechargeable battery may lose its ability to achieve a full
charge. If you experience problems getting the special rechargeable battery
to fully charge, contact your dealer or CASIO distributor about having it
replaced.
•
Never try to remove or replace the watch’s special battery yourself. Use of
the wrong type of battery can damage the watch.
•
All data stored in memory is deleted, and the current time and all other
settings return to their initial factory defaults whenever battery power drops
to Level 5 and when you have the battery replaced.
•
Turn on the watch’s Power Saving function and keep it in an area normally
exposed to bright light when storing it for long periods. This helps to keep
the rechargeable battery from going dead.
Battery Power Indicator and Recover Indicator
The battery power indicator on the display shows you the current status of the
rechargeable battery’s power.
Battery power
indicator
Level
1
2
3
4
5
Battery Power
Indicator
(Charge Soon Alert)
Function Status
All functions enabled.
All functions enabled.
Illumination, beeper, and
sensor operation disabled.
Except for timekeeping and
the
indicator, all
functions and display
indicators are disabled.
All functions disabled.
ll
ll
ll
l l l l
ll
l l l l l l l
ll
ll
ll
ll
ll
ll
l l
l
•
The flashing
LOW
indicator at Level 3 tells you that battery power is very
low, and that exposure to bright light for charging is required as soon as
possible.
•
At Level 5, all functions are disabled and settings return to their initial
factory defaults. Once the battery reaches Level 2 (indicated by
M
indicator)
after falling to Level 4, reconfigure the current time, date, and other
settings.
•
Display indicators reappear as soon as the battery is charged from Level 4
to Level 2.
•
Leaving the watch exposed to direct sunlight or some other very strong light
source can cause the battery power indicator to show a reading temporarily
that is higher than the actual battery level. The correct battery level should
be indicated after a few minutes.
•
Performing multiple sensor, illumination, or
beeper operations during a short period may
cause
RECOV
to appear on the display.
Illumination, alarm, countdown timer alarm,
hourly time signal, and sensor operations will
be disabled until battery power recovers.
After some time, battery power will recover and
RECOV
will disappear, indicating that the
above functions are enabled again.
•
Even if battery power is at Level 1 or Level 2, the Digital Compass Mode,
Barometer/Thermometer Mode, or Altimeter Mode sensor may be disabled
if there is not enough voltage available to power it sufficiently. This is
indicated by
RECOV
on the display.
•
If
RECOV
appears frequently, it probably means that remaining battery
power is low. Leave the watch in bright light to allow it to charge.
Recover indicator
Charging Precautions
Certain charging conditions can cause the watch to become very hot. Avoid
leaving the watch in the areas described below whenever charging its
rechargeable battery.
Also note that allowing the watch to become very hot can cause its liquid
crystal display to black out. The appearance of the LCD should become
normal again when the watch returns to a lower temperature.
Warning!
Leaving the watch in bright light to charge its rechargeable battery can
cause it to become quite hot. Take care when handling the watch to
avoid burn injury. The watch can become particularly hot when exposed
to the following conditions for long periods.
•
On the dashboard of a car parked in direct sunlight
•
Too close to an incandescent lamp
•
Under direct sunlight
Charging Guide
After a full charge, timekeeping remains enabled for up to about six months.
•
The following table shows the amount of time the watch needs to be
exposed to light each day in order to generate enough power for normal
daily operations.
•
Since these are the specs, we can include all the technical details.
•
Watch not exposed to light
•
Internal timekeeping
•
Display on 18 hours per day, sleep state 6 hours per day
•
1 illumination operation (1.5 seconds) per day
•
10 seconds of alarm operation per day
•
10 digital compass operations per week
•
10 hours of altimeter measurements, once per month
•
Stable operation is promoted by frequent charging.
Exposure Level (Brightness)
Outdoor Sunlight (50,000 lux)
Sunlight Through a Window (10,000 lux)
Daylight Through a Window on a Cloudy Day (5,000 lux)
Indoor Fluorescent Lighting (500 lux)
Approximate
Exposure Time
5 minutes
21 minutes
42 minutes
7 hours
Recovery Times
The table below shows the amount exposure that is required to take the
battery from one level to the next.
•
The above exposure time values are all for reference only. Actual required
exposure times depend on lighting conditions.
Approximate Exposure Time
Level 5
Level 4
Level 3
Level 2
Level 1
2 hours
13 hours
6 hours
4 hours
63 hours
29 hours
8 hours
128 hours
58 hours
80 hours
- - - - - - - -
- - - - - - - -
Exposure Level
(Brightness)
Outdoor Sunlight
(50,000 lux)
Sunlight Through a
Window (10,000 lux)
Daylight Through a
Window on a Cloudy
Day (5,000 lux)
Indoor Fluorescent
Lighting (500 lux)
▲
▲
▲
Reference
This section contains more detailed and technical information about watch
operation. It also contains important precautions and notes about the various
features and functions of this watch.
Auto Return Features
•
The watch automatically returns to the Timekeeping Mode if you do not
perform any button operation for two or three minutes in the Data Recall,
Alarm, Digital Compass, or Barometer/Thermometer Mode.
•
If you do not perform any button operation while in the Altimeter Mode, the
watch automatically returns to the Timekeeping Mode after nine or 10
hours.
•
If you leave a screen with flashing digits on the display for two or three
minutes without performing any operation, the watch automatically exits the
setting screen.
Power Supply
This watch is equipped with a solar cell and a special rechargeable battery
(secondary battery) that is charged by the electrical power produced by the
solar cell. The illustration shown below shows how you should position the
watch for charging.
Example:
Orient the watch so its face is
pointing at a light source.
•
The illustration shows how to position a
watch with a resin band.
•
Note that charging efficiency drops when
any part of the solar cell is blocked by
clothing, etc.
•
You should try to keep the watch outside
of your sleeve as much as possible. Even
if the face of the watch is only partially
blocked from light, charging will be
significantly reduced.
Solar cell
Scrolling
The
A
and
C
buttons are used on the setting screen to scroll through data
on the display. In most cases, holding down these buttons during a scroll
operation scrolls through the data at high speed.