Case WX90, Руководство по обслуживанию

Страница: 49 / 51

SAFETY PRECAUTIONS
SR2-2-25
15501 9-35990
AVOID HEATING NEAR PRESSURIZED
FLUID LINES
• Flammable spray can be generated by applying heat
near pressurized fluid lines, resulting in severe burns
to yourself and bystanders.
- Do not heat by welding, soldering, or using a torch
near pressurized fluid lined or other flammable
materials.
• Pressurized lines can be accidentally cut when heat
goes beyond the immediate flame area.
- Install temporary fire resistant guards to protect
hoses or other materials when engaging in
welding, soldering, etc.
AVOID APPLYING HEAT TO LINES
CONTAINING FLAMMABLE FLUIDS
- Do not weld or flame cut pipes or tubes that contain
flammable fluids.
- Clean them thoroughly with non-flammable solvent
before welding or flame cutting them.
F5840
F1470
AVOID HIGH PRESSURE FLUIDS
• Avoid this hazard by relieving pressure before
disconnecting hydraulic or other lines. If inhaled,
these fumes may cause sickness.
- Avoid breathing potentially toxic fumes and dust.
- Do all such work outside or in a well-ventilated
area.
- Dispose of paint and solvents properly.
- Remove paint before welding or heating:
1. If you sand or grind paint, avoid breathing the
dust. Wear an approved respirator.
2. If you use solvent or paint stripper, remove
stripper with soap and water before welding.
Remove solvent or paint stripper containers
and other flammable material from area. Allow
fumes to disperse at least 15 minutes before
welding or heating.
F1446