SECTION 1
1-18
UNLOADING THE MACHINE FROM A
TRAILER
Unloading procedure may vary dependent upon
whether the front attachment is installed or not.
WITH FRONT ATTACHMENT INSTALLED
Travel slowly in reverse along the flatbed.
Once at the flatbed end and before the machine
starts falling forward onto the ramp (shifting the
position of its centre of gravity), rest the bucket flat
side onto the ground (the angle between the booms
should be 90° to 110°).
Drive slowly forward while retracting the boom,
extending the arm and repositioning the bucket rest-
ing onto the ground until the entire machine is
unloaded.
IMPORTANT:
to avoid damaging the front attach-
ment, observe the following while unloading the
machine:
minimum angle between boom and arm should
never be lower than 90° and the bucket should
never suddenly hit the ground.
WITHOUT FRONT ATTACHMENT
Travel forward down the ramp.
31
32
