Case CX135SR, Руководство оператора

Страница: 71 / 186

CHAPTER 4 - OPERATING INSTRUCTIONS
4-11
6-34551NA Issued 8-04 Bur
CT02C201 Figure 26
TRANSPORTING THE MACHINE
BY RAIL
S i n c e t ra n s p o r t by r a i l i s s u b j e c t t o s p e c i a l
regulations, consult an approved organization.
ON A TRAILER
Make sure you know the safety rules and regulations
before transporting the machine. Make sure both
trailer and machine are fitted with the right safety
equipment.
1. Place a block behind the trailer wheels. Install the
trailer side extensions (if equipped).
CT02C196 Figure 27
2. Select the engine auto idle function on the
right-hand lever of the control arm.
CT02C227 Figure 28
3. Raise the dozer blade. (if equipped)
4. Machine with attachment
Place the machine in line with the trailer, with the
travel reduction gears towards the access ramps.
Raise the attachment and bring it to about twenty
centimeters above the bed of the trailer.
CT02C197
Figure 29
IMPORTANT: In this position, the travel and
steering controls are reversed.
WARNING: If the machine is equipped with
the 2.85 m (9 ft. 4 in) arm, for any
transportation of the machine, the hooking
point on the head of the arm cylinder must be
in the transport position. See Putting the 2.85
m (9 ft. 4 in) arm in the transport position.
WARNING: This machine could slip and fall
from a trailer or ramp and cause serious
injury. Make sure the trailer and ramps are
clean. The machine should be in line with the
trailer before being loaded.
WARNING: It is mandatory to remove the
counterweight before undertaking any travel
without the attachment or transporting the
machine without the attachment.