cascade corporation 220D, Руководство по обслуживанию

Страница: 18 / 28

6817684
ERVICE
S
16
4.3-4
Char-Lynn
®
Drive Motor
Reassembly
1
Install the brass shim into the pressure seal side of the
flange. Install wiper seal and pressure seal into the
flange. The pressure seal must be seated evenly.
2
Place the bearing race in the flange, seated evenly with
pressure seal and flange.
3
Lubricate the flange seal with petroleum jelly and seat in
lip of flange on the pressure seal side, as shown.
4
Install thrust bearing onto the output shaft.
5
Install the flange onto the output shaft with the pressure
seal side against the output shaft.
6
Clamp housing into the vise with the flange side facing
upward.
7
Install the output shaft/flange assembly into the housing.
8
Apply Loctite sealant 242 (blue) or equivalent to the
four holes of the housing and the four capscrews. Wipe
away any excess sealant. Install the four capscrews
and tighten in a criss-cross pattern to 250 in.-lbs.
(28 Nm).
IMPORTANT: Capscrews must be clean and dry.
RR0633.eps
Brass Shim
Wiper Seal
Pressure Seal
Bearing Race
Flange
Flange Seal
4.3-3
Char-Lynn
®
Drive Motor
Inspection
• Remove all Loctite residue from the threaded holes.
• Clean all parts with solvent and blow dry. Do not use
paper or cloth towels.
• Inspect all parts for small nicks, burrs or scratches.
Remove imperfections with emery cloth. Replace parts
where imperfections could not be removed.
• Inspect the flange seal seats for scratches. Check for
cracks in the flange area that could cause leakage.
RR0861.eps
RR0862.eps
8
7
4
5
Output Shaft