Casall Benefit B420, Инструкция по сборке

Страница: 12 / 14

12
“Drawing A” and have “Bi” sound at the same time.
Drawing A Drawing B
2. Get access to the set-up mode of TIME/DISTANCE/CALORIES/PULSE.
When you are in each set-up mode. For instance the time set-up, when the time value
is blinking, you can press "SET" button to adjust the number. Press "Mode" button for
confirmation and skip to next set-up. The set-up of DISTANCE & CALORIES is the
same as TIME set-up.
3. After entering RPM value, and setting up the TIME, DISTANCE, CALORIES/PULSE. In
SCAN mode shown as "Drawing C". RPM/SPEED/TM/DIST/CAL/PULSE will skip to
display every 6 seconds. The order is as below "Drawing C"
Drawing C
4. You can also press "Mode" button to select single function display except RPM &
SPEED function. The RPM & SPEED function will switch display.
5. When there is any function has been preset the target (TIME or DISTANCE or
CALORIES), the function will be counting down from the preset to zero while the
training starts. Once the target is achieved to zero, the monitor start to beep for
8 seconds, and the function will be counting up from zero directly if the training
is going.
6. RECOVERY
(1) When press "RECOVERY" button, the RECOVERY function will work. At this
time only PULSE and TIME is working, other function will not be displayed, and the
Sensor Input is not available. TIME start to count down from "00:60". Pulse signal
will be blinking according to user's pulse. When count down to "0", it will show F1~F6.
(2) LCD display as follows: (RECOVERY start condition & end condition)
Drawing D Drawing E
(3) If the count down action to 00:00 is not completed and there is no pulse signal.
The count down action have to be done and shown F6.
(4) If you press the RECOVERY button prior to count down to 00:00, it will be end
the function and there will be no display at all.