Casada braintronics, Руководство пользователя

Страница: 24 / 135

47 46
INSTALLATION INSTRUCTIONS FOR ARMRESTS
1. Remove all parts from the boxes and remove the packaging material. Make sure that you do
not throw away any small parts with the packaging material. For assembly, you need a Phil-
lips screwdriver or cordless screwdriver with a bit set. When using a cordless screwdriver,
please ensure that it is not set too high, as this could destroy the screws or threaded holes.
2. To begin the assembly, the chair must first be set in the upright position. Pick up the remote
control and connect it. You will find the connection on the right-hand side at the front part
of the seat, while standing in front of the chair (Figure 1). Now plug the chair to the power
socket. Make sure the main switch next to the power cable is in I position. Press the on/
off button twice so that the chair moves to the upright position. Afterwards, disconnect the
chair from the power supply socket.
Figure 1 Figure 2
3. Attach the armrest to the front of the chair (Figure 2) and hook the front side into the
bracket on the frame, which is located at the front corner of the seat.
4. After the front part of the armrest is firmly hung, connect the air hoses and connector to the
counterparts which are marked in colour and number at the back of the chair (Figure 3).
Figure 3 Figure 4
5. Place the rear side panel on the 2 plastic pins that have holes into the side panel. Make sure
that the cables and hoses are not squeezed (Figure 4).
6. Fix the rear side of the side panel with 2x M5 screws (Figure 5).
7. Then fix the front of the side panel with 2x M5 screws. The threads are located at the inner
front side of the side panel that is hooked in (Figure 6).
A
SSE
M
BL
Y
A
N
D
I
NS
TA
LL
A
TI
O
N
Assembly and Installation
A
SSE
M
BL
Y
A
N
D
I
NS
TA
LL
A
TI
O
N
Assembly and Installation
Figure 5 Figure 6
8. Use the matching decorative cover and place it with its clip over the holes on the arm-
chair and click it in place (Figure 7).
Figure 7
INSTALLATION FOR LEGREST
1. Release the bracket for the foot section by removing the cross screw (Figure 2).
2. Place the footrest in front of the chair and connect the wires and the air hose (Figure 1).
Insert the cable and hose excess into the chair, lift the footrest using the two bolts on the
right and left into the bracket of the chair.
1
2