5.
Thread the two 8-32 screws half way into the two threaded
holes on the switch housing. See FIG. 4
6.
While holding light fixture up to the fan, attach the wires
from the fan switch housing and the wires from the light fixture
together (black-to-black or blue-to-black and white-to-white)
by twisting the bare ends of the wires together. Then secure
the splices by threading on the porcelain wire nuts provided.
Test the secureness of each splice by pulling on the wire nut.
Check that there is no bare wire showing from the wire nut
then cover both connections with electrical tape.
7.
Align the two 8-32 screws on the switch housing with the
two key slots on the housing cover. Rotate light fixture
clockwise, make certain screw heads have rotated to the
narrow end of the slot.
CAUTION: Make sure no wires are pinched between light
fixture and switch housing. Tighten the screws to secure
light fixture.
8.
Install the light bulbs. Do not exceed the maximum
wattage indicated on the light fixture.
CAUTION: Make certain to remove dust and oil from the
halogen light bulbs after installation. Failure to do so will
shorten bulb life.
9.
Align the four (4) indents in the glass with the four (4) spring
tabs in the shade holder and turn in either direction 1/8 turn
(2"). Make certain spring tabs lock onto glass. See FIG. 5
(Skip step 10 if this light fixture is not intended for
mounting to a 3 speed pull-chain fan)
10.
For 3 speed fan series. Connect the fob pull chain.
Repeat for both switches. See FIG. 6
FIG. 4
FIG. 6
SWITCH
HOUSING
8-32 SCREW
PORCELAIN
WIRE NUT
KEY SLOT
LIGHT
FIXTURE
LIGHT BULB
GLASS
(NOT INCLUDED)
FOB PULL
CHAIN
CAUTION: Make sure no wires are pinched
between light fixture and switch housing.
I N S T A L L A T I O N
FIG. 5
INDENT
(GLASS)
SPRING TAB
(SHADE-
HOLDER)
P/N 1943930 REV.B P/D JUN96PDG 8A265
