Casablanca Concert Breeze, Руководство пользователя

Страница: 9 / 10

16 17
C
onCert
B
reeze
INSTALLING ON A HUNTER CEILING FAN
Step 1. Unscrew the three screws from the
upper switch housing. Disconnect the 9-pin plug
connectors. Remove the lower switch housing.
Step 2. Push the plug button from inside the
lower switch housing to remove the plug button
and switch housing cap. NOTE: Save the plug
button and switch housing cap should you choose
to remove the light fixture in the future.
9-Pin Plug
Connector
Lower Switch
Housing
Plug Button
Screw
Steps 1-2
CAUTION: If your fan is operated by remote
control, take care not to damage the small
components on the circuit board inside the housing.
Step 3. Feed the two wires from the light kit up
through the center hole in the lower switch housing.
Step 4. Screw the threaded rod from the light kit/
speaker assembly into the center hole in the lower
switch housing.
Step 5. Install the nut and washer onto the threaded
rod from the light kit/speaker assembly.
Step 6. Remove the wire connectors from the two
wires in the switch housing labeled “Connect Light
Here” or “For Light Use.”
Threaded
Rod
Light Kit/
Speaker
Lower
Switch
Housing
Wires
Note: Align the fan pull chain
with the chain guide.
WIRING AND INSTALLING LIGHT KIT/ SPEAKER
Cap Assembly
Screws
Wire
Connectors
Step 1. Connect the black wire from the light kit/
speaker and the blue wire from the canopy.
Step 2. Connect the white wire from the light kit/
speaker and the white wire from the canopy.
Step 3. Secure all wire connections using wire
connectors.
CAUTION: Be sure no bare metal wires or wire
strands are visible after making the connections.
Wire
Connections
Steps 1-3
Lower Switch
Housing
Upper
Switch
Housing
Steps 4 – 7
Housing
Assembly Screw
Step 4. Lift the light kit/speaker to the upper switch
housing on the bottom of the fan switch housing.
Step 5. Connect the upper plug connector from
the motor to the lower plug connector in the lower
switch housing assembly.
Note : Both plug connectors are polarized and will
only fit together one way. Make sure the connectors
are properly aligned before connecting them.
Incorrect connection could cause improper operation
and damage to the product.
Step 6. Align the side screw holes in the upper
housing and the lower switch housing.
Step 7. Attach the light kit/speaker with three cap
assembly screws.
Go to Completing Installation of
Light Kit on Page 11