background image

6

7

a

ntion

MOUNTING RECOMMENDATIONS

SLOPED CEILING INSTALLATION

Before mounting your Casablanca fan, read the following helpful recommendations. The location of the 

fan, air circulation, and fan size are all important factors to consider before installation.

Location
Ceiling fans have practical uses in almost every room in your 

home. We suggest you follow these mounting recommenda-
tions as you decide where to install your Casablanca fan. 

•  For safety reasons, the fan blades must be a minimum of 7' 

above the floor. 

•  Do not locate the fan in a doorway or above a swinging door. 
•  In bedrooms, fans work best when mounted above the foot of 

the bed.

•  Over pool tables, be sure to provide plenty of clearance to avoid 

damage from pool cues.

•  In kitchens be sure to allow for open cupboard doors to clear 

the fan blades.

•  Do not install a fan close to or over a pool or spa. High humidity combined with corrosive gases will 

destroy the finish and warp the blades.

Fan_Size
Variable fan speed capability permits the use of a full-size 52" fan even in smaller rooms. For very large 

rooms, two fans may be needed.

Calculation of Ceiling Angle
Use the tear-off Ceiling Angle Template card inserted 
in this manual. It provides you with a simple “go” 
or “no-go” for installing your fan on a sloped 
ceiling.

7' minimum

When to Use Extension Poles
For optimum performance and appearance, 
an extension pole should be used with your 
Casablanca fan when installing on high (cathedral) 
ceilings or sloped ceilings. Casablanca offers 
standard poles in increments of 6" up to 5'. Custom 
poles are available in lengths up to 9'9". See your 
Authorized Casablanca Dealer for details.

Blades must be a 

minimum of 7 feet 

above the floor

Extension 

Pole

Maximum 

®

 

angle 32º

This slope is less than 32º.

It is OK to install your fan.

This slope is 32º.  This is the maximum 

slope that will allow the fan to hang 

straight down.  It is OK to install your 

fan.

This slope is more than 32º.  Your fan will 

not hang straight down, an adaptor is 

necessary.  Contact your local Authorized 

Casablanca Dealer in regards to purchasing 

a “Sloped Ceiling Adaptor.”

Note: Fan may wobble or vibrate if pole length is 
not long enough and inside blade is too close to 
downslope or side wall. Extending pole length will 
usually solve problem.

EXAMPLE 3

EXAMPLE 2

EXAMPLE 1

Suggested Extension Pole Lengths

 

Ceiling Height 

Pole Length

 

8' 0" 

4.5"

 

8' 6" 

4.5"

 

9' 0" 

12"

 

9' 6" 

12"

 

10' 0" 

18"

 

11' 0" 

24"

 

12' 0" 

36"

 

13' 0" 

48"

 

14' 0" 

60"

GETTING STARTED

FAN INSTALLATION

Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either 
the circuit breaker or fuse box), lower the old 
fixture and disconnect the wiring. Check the 
ceiling fixture outlet box to be sure it is marked 
“Approved for Ceiling Fan Mounting.” If it is not, 
a new box must be installed. 

Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located 
where you wish to place your Casablanca fan, 
an approved ceiling fixture outlet box must be 
installed and wired.

Note: The weight of this fan is

 

22 pounds.

WARNING!

To reduce the risk of fire, electrical shock, or 

personal injury, mount to outlet box marked 

“Acceptable Fan Support of 22.7 kg (50 

lbs.) or less” using the mounting hardware 

provided with the outlet box or directly to 

structure.

CEILING HARDWARE (not to scale)

WARNING!
Support directly to building  structure 
only.

MOUNTING BRACKET INSTALLATION

Note: After removing the old fixture, check the 
outlet box to insure that it is supported by a 
joist or beam across its upper surface. If not, a 2 
x4 stud must be installed.

Mounting Bracket

#8 Wood Screw and Washer (2)

#10 Wood Screw (2)

Step_1._ Drill two pilot holes into the wood support 
structure through the outermost holes in the outlet 
box. The pilot holes should be 9/64” in diameter.
Step_2._ Thread the lead wires from the outlet box 
down through the hole in the middle of the ceiling 
plate.

Содержание Antion C39G199L















Отзывы: