P4
10. Set up motor position
10. Set up motor position
10a. Remove the set screw between yokes &
adjust motor to preferable position
10b. Line up the angle labels as below
：
Motor Yoke
Pipe Yoke
Set Screw
10c. Insert back the set screw removed from step 10a. and tighten it.
For 45 degree
For 0 degree
Pipe Yoke
Motor
Yoke
Motor Yoke
0
Pipe
Yoke
45 0
Set screw
Motor
Yoke
Pipe
Yoke
45
0
45
90
Motor Yoke
45 90
Pipe
Yoke
45
0
Set screw
For 90 degree
Set screw
Pipe
Yoke
Motor
Yoke
Motor Yoke
45 90
Pipe
Yoke
90
Set Screws
Key Holes
Canopy
Mounting
Bracket
9a. Push up the Canopy until the two screws on
mounting bracket are engaged with Key Holes
in canopy.
9b. Rotate the canopy slightly until the two screw heads
are in the small end of the Key Holes.
9c. Tighten both screws.
9. Canopy installation
9. Canopy installation
From House
From House
From Fan
From Fan
From Remote
From Remote
White
Follow diagram below and make sure that all exposed wires are secured inside wire nuts or terminal block.
Note : Wires from house may vary in color and may not include ground wire ( green ). After wiring is
completed, gently push wires into junction box with wire nuts pointing upward.
White
White
White
( Motor - N )
Black
Black
( AC - N )
Black
Black
Blue
( Motor - L )
( AC - L )
Blue
( for light kit )
Green
Green
( from downrod )
( for ground wire )
Green
( from mounting bracket )
8-2. Make wire connection
- ( for 100~127VAC/60Hz )
- ( for 100~127VAC/60Hz )
NOTE:
Light kit is not adaptable for the fans with this angle at 90 .
(Light kit might hit by the fan blades)
