Yoke
Yoke Cover
Lead Wires
Downrod
Canopy
6a.
1.Insert the Yoke Cover and Canopy through downrod
assembly as shown above.
2.Feed motor lead wires through downrod assembly.
3.Insert the downrod assembly into yoke.
1.Insert the cross pin through Yoke and downrod and secure
with Cotter Pin.
2.Tighten both set screws to further secure downrod.
3.Tighten hex nuts existing on set screws toward yoke to prevent
set screws from loosening.
4.Pull down the yoke cover on top of housing to cover the yoke.
Cotter Pin
Cross Pin
Downrod
Set Screws(2)
Hex nut(2)
6b.
6. Yoke & downrod assembly
6. Yoke & downrod assembly
P3
(1)
Lift fan assembly onto mounting bracket.
(2)
Carefully lift fan assembly onto mounting bracket.
Rotate fan so that the notch on the ball engages the
ridge in the mounting bracket.
7. Hanging the fan
7. Hanging the fan
Mounting
Bracket
Ball Notch
Mounting
Bracket
8-1. Prepare Remote Control
8. Make wire connections - For use with remote controller
8. Make wire connections - For use with remote controller
This unit has 16 different code combinations.
1.Setting the code on the TRANSMITTER
A. Remove battery cover.
B. Slide code switches to your choice of ON or OFF position. Use a small screwdriver or
ball point pen to slide each switch firmly up or down.
C. Install 9V DC battery ( not included ).
D. Install battery cover on transmitter.
2.Slide code switches “on the receiver “ to be the SAME POSITIONS as you have set on the transmitter.
Receiver
Code Switches
1
2
3
4
Transmitter
Code Switches
1
2
3
4
