5. POWER PACK OPERATION
8
5
.1
Timer Switch
This switch posi on determines whether the unit is manually turned on or automa cally
controlled by the Timer.
•
Auto Posi on –
the me clock controls the opera ng hours. See sec on 6 for Timer Se ng.
•
Manual Posi on –
the unit is on and both the pump AC Socket and Cell will be powered up.
5
.
2
Cell Switch
This switch posi on determines whether the Cell is turned on or off when power is supplied to
it from the above Timer Switch.
•
OFF Posi on
– even if the Timer Switch is powered on there will s ll be no power to the Cell.
•
ON Posi on
– if Timer Switch is powered on then there will be power to the Cell.
•
Changing Direc on
– while the unit is running you can change direc on by turning off the
Cell Switch, wait 3 seconds then turn it on again. The direc on should change. If it does not
then repeat this again and it should change direc on.
5
.
3
Circuit Breaker
A Circuit Breaker is an automa cally operated electrical switch designed to protect an electrical
circuit from damage caused by overcurrent, overload or short circuit. It can be reset by pressing
the bu on in a er it has tripped. It may be damaged if you supply excessively high levels of salt
through the Cell.
5
.
4
AC Socket (Pump Outlet)
The AC Socket allows the pump to be electrically operated and controlled by the Power Pack.
WARNING:
If you fail to control the pump this way then you must allow for a flow switch
mechanism to control the electrical supply to the Power Pack, so as to prevent gas build up if the
pump stops.
5
.
6
+ and – Bu ons
Simply press the – Bu on and the chlorine produc on will automa cally decrease by
approximately 15%. Press the + Bu on and the chlorine produc on will increase by
approximately 15%. When all green LED Output Lights are on this indicates 100% output.
5
.
7
Output LEDS’s
There are 8 Output LED’s on your
Talline
display. Each one of the LED’s indicate the
chlorine produc
tio
n output.
5
.
5
Junc on Box
The Junc on Box allows rec fied DC voltage to be coupled to the Cell. This is where the Cell
cable is connected to the Power Pack.