NETWORK AUDIO OVERVIEW
CHANGE THE IR CODE
IR Code (DMS-550/600 only)
. If your IR remote control shares common Phillips RC-50 codes
with your other products, such as volume control, power, etc., you can change the command codes
in the IR remote and DMS-550/600 as follows.
The default settings are IR Code A (Blue Power
LED)
. To change, follow these steps.
1.
Select
IR Code
and
press the
right arrow key.
2.
Highlight
IR Code A (Red Power LED)
and
press
Enter
on the IR remote.
You’ll notice the IR remote no longer works after change the setting in the DMS. You now need to
match the IR remote codes to the same IR Code set of the DMS.
3.
Press and hold the
Menu
button of the IR remote
for 5 seconds until the Power button flashes
RED. Now the DMS and IR remote control IR Codes will match with the DMS and should not
interfere with your other electronics. To switch back, simple repeat processes in steps 1-3 to IR
Code A (Blue Power LED).
25