Carver 396 Motor Yacht 2003, Руководство пользователя

Страница: 97 / 234

S
ECTION
4 I
NTERNAL
S
YSTEMS
85
3808 4/99
2. Reinstall the seawater strainer. If the strainer
leaks when the air conditioning seacock is opened,
close the seacock, then check the strainer for cor-
rect installation.
3. A single pump supplies all three air conditioning
units with seawater. Open the seacock that sup-
plies seawater to the pump. The seacock is located
near the strainer.
4. Supply AC power to your boat. Refer to the "Shore
Power" or "Generator Power" portion of Section
3 to do this.
5. If you are using shore power, switch the Shore 1
and Shore 2 circuit breaker groups on the AC
Control Center "ON".
If you are using generator power, switch the upper
and lower Generator circuit breaker groups on the
AC Control Center "ON".
Do not run the air conditioning system’s water pump
when the seacock that supplies seawater to the
system is closed. Operating the pump with no sea-
water can damage it.
6. Switch the A/C Water Pump circuit breaker on the
AC Control Center "ON".
7. Switch all three A/C Unit circuit breakers on the
AC Control Center "ON". These breakers supply
power to the controls for each air conditioning unit.
8. Verify that seawater is being pumped through the
air conditioning units. As the seawater exits the
units, it flows out of the discharge thru-hull fittings
in the boat’s hull. Refer to the "Thru-Hull Fit-
tings" portion of Section 9 for the location of these
thru-hull fittings.
9. Use the controls for each air conditioning unit to set
the desired temperature. The unit controls are
located in the aft stateroom, salon, and forward
stateroom. Refer to the OEM information for details
on operating the air conditioning controls.
Open Closed