Carver 396 Motor Yacht 2003, Руководство пользователя, Страница: 46 / 234

DC E
LECTRICAL
S
YSTEM
S
ECTION
2
34
3808 8/99
forward head, indicates the amount of waste in the aft
waste tank. To supply power to the monitor, switch this
breaker "ON".
Grey Water Monitor
This breaker controls the flow of electricity to the moni-
toring system, including the grey water monitor gauge,
for the optional grey water system. To supply power to
the system, switch this breaker "ON".
Propane
This breaker controls the flow of electricity to the op-
tional propane stove in the galley. Before switching this
breaker "ON", read both the propane stove OEM infor-
mation and the " Propane Stove " portion of Section 4 .
Spare
This breaker is reserved for aftermarket accessories you
install on your boat.
Bridge Electronics
This breaker controls the flow of electricity to the
flybridge’s electronic equipment, such as the optional
VHF radio, optional auto pilot, and optional radar
system. To provide power to this equipment:
1. On the Safety Breaker Panel, switch the Main -
Two breaker "ON".
2. Switch the Bridge Electronics breaker "ON". Refer
to the OEM information for details on operating the
equipment.
Forward, Mid, and Aft Bilge Pumps
Don’t forget to turn the bilge pumps off. Leaving the
forward, mid or aft bilge pump on for extended periods
of time could cause excessive wear to the pump.
These breakers control the flow of electricity to the
forward, mid, and aft bilge pump controls, respectively.
These controls are located at the helm. Switch these
breakers "ON" to activate the bilge pump controls.
A T
IP
F
ROM
C
ARVER
!
A certain amount of water will
always collect in your boat's
bilge, especially in the bilge area
where the shaft logs are located.
The small amount of water that
normally accumulates is usually
not enough to activate the bilge
pumps’ automatic float switches.
While underway and on plane,
use the helm switch to turn your
bilge pumps on manually and let
them run for 30 seconds to a
minute.