Carver 12-10, Руководство по эксплуатации, установке и обслуживанию, Страница: 24 / 104

Carver Inc 4-6
4.5 LAMINATING PRESSES
Introduction
We are pleased to provide a CARVER Laminating Press for your operations. Although this equipment is a standard
apparatus for general laminating work, these presses have wide use for other applications where heating and chilling
under pressure is required. Many of these presses are in daily use by the Armed Forces, Government Agencies,
Universities and Industry for important jobs where securities, ease of operation and quality production are essential.
Description
The press is a complete, self-contained, hand-operated unit ready for connection to an electrical outlet and cooling
source. No special wiring or plumbing is required for installation, nor is any previous skill needed for operation. Press
Models 150-C and 154-M are supplied complete with all operating accessories including hose connections, extension
cord, polished plates, blotters, holding plates, polished chrome plates, thermometers, interval timer, oil and operating
instructions in the service manual. Model 30-12-L is not supplied with any laminating accessories.
Features
CARVER
Laminating Presses incorporate two separate openings. The upper chamber features heating plates, while the
lover chamber utilizes channeled cooling plates. This specially developed feature permits simultaneous heating and
cooling of separate charges under the exact heat and pressure required to suit the particular plastic used. This results in
faster, more efficient production of laminations.
Another feature of this press is the variety of standard laminating accessories available. These include CARVER
polished chrome plates. These plates have a highly polished finish and have wide use for laminating, molding and
similar finishing work where good surface finish is required. A variety of sizes are available from stock. We also carry
in stock laminating-type blotters for use with these plates which are available in a variety of sizes.
Laminating Equipment
This press is shipped with various accessories; the purpose of each and their proper use is outlined below.
Holding Plates:
Six (6)-holding plates are supplied. They are made of hard aluminum alloy for quick transfer of heat. They provide for
holding one or more laminations in order to keep the press in continuous operation (one heating, one cooling and one
staged, ready for use). These holding plates are used on the top and bottom of each lamination as outlined in the section
titled "Lamination".
Holding Clamps: (Optional)
1. The holding clamps are used for maintaining pressure on a lamination while transferring it from the hot to the
cold opening of the press (see Laminating Procedure). The holding clamps are adjustable so that they may be
use for stacks of laminations of varying thickness. The clamps may be adjusted as follows:
2. Hold the clamp in one hand with the lever up against the main body of the clamp.
3. Back off the adjusting screw by turning it in a counterclockwise direction (to the left) until the jaws are opened
just enough to be placed over the stack of laminations, outside the holding plates.
4. Open the clamp lever.