Carrol Touch TouchSystems CarrollTouch Prog, Руководство программиста

Страница: 97 / 274

Chapter 7 - CTKERN CARROLL TOUCH
7-10 Touch System Programmer’s Guide
Dx
= Pathname to calibration data file.
x
may be any valid
pathname. The default is
CALIB.DAT
in the current
DOS drive and directory.
The command line is case-insensitive and the command line parameters
may be arranged in any order. An example command line is:
CTKERN K59 t57
If you use the uninstall command line parameter (
U
) to uninstall a
CTKERN driver that is installed on an interrupt other than the default,
you must also specify the CTKERN software interrupt on the command
line by using the
K
parameter. For example, to uninstall a copy of
CTKERN that was installed on software interrupt 59, use the following
command line:
CTKERN U K59
Error Messages
Table 7-1 defines the error messages and meanings for the CTKERN
driver.
Table 7-1. CTKERN Error Messages
Message:
A CT driver is already installed at
software interrupt xxH.
Meaning: A CT driver has been previously installed on S/W
interrupt
xxH
. CTKERN looks only for the string
CT
DRIVER -
. It does not look for a specific type of driver.
Message:
Bad calibration entry in CALIB.DAT as
follows:
<the text line in CALIB.DAT that has the problem>
Meaning: A calibration entry in
CALIB.DAT
has bad syntax.
Message:
CTKERN installation failed.
Meaning: This error message accompanies other error messages
and indicates that installation was aborted.