Pairing sensors to the Wireless Adapter using SensorBuilder
Wireless Sensors
CARRIER CORPORATION ©2018
Installation Guide
All rights reserved
23
3
Run SensorBuilder_Setup.exe.
4
Start the SensorBuilder application.
•
If the USB Radio driver installed correctly, the
USB Port
field should show something similar to the image
below.
•
If the driver did not automatically install correctly, see
To install the USB Radio driver
(page 25).
5
Click
Start
.
NOTE
The USB Radio can talk to only one application at a time. If you need to run SensorBuilder and SensorScan
simultaneously, you can do either of the following:
•
Use two USB Radios.
•
Turn off communication with the USB radio in the current application, then switch to the other application and
turn on the USB communication.
Step 2: Pair sensors to the Rnet Wireless Adapter
1
In SensorBuilder's
Driver
pane, right-click the Wireless Adapter and then select
Discover devices
. Any
Wireless Adapters within radio range will appear in the
Devices
pane. The Wireless Adapter with the lowest
dB is the one closest to you.
2
In the
Devices
pane, click the Wireless Adapter, and then click
Yes
in the
Read device configuration
box. The
sensor is now in Learn mode and will stay in Learn mode while SensorBuilder is open.
NOTE
The Wireless Adapter is locked during Learn mode so that no other user can configure it. If any other
user clicks on it in the
Devices
pane, they will see a small red lock on it. Learn mode ends, unlocking the
device, when you close SensorBuilder or you right-click the Wireless Adapter and select
End LEARN mode
.
Should you delete the Wireless Adapter from the
Devices
pane or clear the
Devices
list while the Wireless
Adapter is in Learn mode, the Wireless Adapter will remain locked for 5 minutes.
3
Optional: In the
Devices
pane, right-click the Wireless Adapter, and then select
Rename
. In the
Short
description
field, enter an intuitive name that denotes the location or use of the Wireless Adapter, and then
click
Save
. The name is stored in SensorBuilder for the device ID.
4
Install each sensor's battery. See the appropriate battery installation instructions in
Installing the Wireless
Adapter and sensors
(page 30).
NOTE
The Pro-F has a built-in battery.
Содержание WIRELESS ADAPTER
Страница 65: ......