![background image](http://html1.mh-extra.com/html/carrier/touch-pilot-33cntpilot/touch-pilot-33cntpilot_installation-and-operation-instructions-manual_2564188009.webp)
7
ALARMS – Pressing the Main Menu's
button
will allow you to display device alarms from a selected Alarm
History table in the attached device or network alarms from
the CCN. To view device alarms, use the Alarm Table but-
tons (if the device has 2 or more alarm tables) or the
History button (if there is only 1 alarm table). To view
alarms from the CCN, use the Network button. Note that if
the Display is unattached or the attached device has no
Alarm History tables, the Table List screen will only con-
tain a Network button. Alarm History is a static screen. To
refresh the alarm list, you must exit and re-select the Alarms
option.
RESET – Pressing the Main Menu's
button will
allow you to turn off the Display’s alarm indicator light.
The light will stay off until a new alarm condition is de-
tected.
SCHED – Pressing the Main Menu's
button al-
lows you to display a CCN time schedule from the attached
device. If the attached device has just one time schedule,
the Display will bring up the Time Schedule screen. If the
device has multiple time schedules, the Display will show a
list of schedules from which you can select the one you
wish to access. The Time Schedule screen consists of eight
buttons, one for each occupancy period. Press a period
button to show the Period Edit dialog box for that period.
You will be prompted to save changes upon exiting the
Time Schedule screen.
STATUS, SETPNT, SERVICE, MAINT OR CONFIG – Press-
ing the
buttons allows you to display a status display,
setpoint, service configuration, maintenance, or configura-
tion table from the attached device. If there is just one
table of that type the Display will bring up the Table screen.
If the device has multiple tables of that type, the Display
will show a list of tables from which you can select the one
you wish to access.
As you make changes to values in these tables, the new
values will be displayed. On pressing a Navigation
pushbutton to exit the current screen, a confirmation mes-
sage will be displayed. Pressing
will save and down-
load the new values to the attached device. Pressing
will exit the screen without saving or downloading the modi-
fied values. Pressing
will cancel the changes and re-
turn you to the screen for further changes.
Setup Menu Screen –
This screen (shown in Figure 11)
is accessed by pressing the Main Menu's Setup button.
Figure 11 - Setup Menu
The Setup Menu provides access to setup and configura-
tion functions for the Display itself. Table 3 summarizes
Setup Menu functions.
Table 3 - Setup Menu
Pressing
Allows you to...
REGIONAL
specify the time and date format and units
base.
LANGUAGE
select the Display's active language and
font.
CONTRAST
adjust the LCD contrast. Press and hold
the
button to increase/darken or the
button to decrease/lighten the cur-
rent contrast. If when adjusting contrast
the screen becomes unreadable, follow the
instructions under Calibrate below to re-
turn the screen to the factory default.
BACKLIGHT
specify whether backlighting should be
kept on at all times or turned off during
inactive periods.
CALIBRATE
adjust the LCD touch screen calibration.
Using a fine point device, touch the
screen in the center of the circular targets
located first in the upper left and then in
the lower right corner of the screen. If,
during the calibration procedure, a mis-
take is made the screen may be reset to
factory defaults by simultaneously touch-
ing the screen and performing a power
cycle. When prompted, touch the screen
anywhere.
(Table 3 - continued on the next page)
Содержание Touch Pilot 33CNTPILOT
Страница 2: ...ii ...