Carrier i-Vu XT, Руководство по установке и запуску

Страница: 41 / 50

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022
Installation and Start-up Guide 38 All rights reserved
SYS (System Status) Tricolor LED
Color Pattern Condition Message in Module
Status Possible Solution
Red
2 blink Restarting after an abnormal exit Auto restart delay due to
system error on startup After 5-minute delay has
expired, if condition occurs
again then cycle power
Red
4 blink Firmware image is corrupt Firmware error Download driver again
Red
Fast
blink Firmware error has caused the
firmware to exit and restart Fatal error detected No action required
Green
1 blink No errors Operational No action required
Green
2 blink Download of driver is in progress Download in progress No action required
Green
3 blink BACnet Device ID is not set Download required Download the router
Green
Fast
blink Installation of recently downloaded
driver is occurring N/A No action required
Blue
On Router is starting up N/A No action required
Blue
Slow
blink Linux (operating system) is starting up N/A No action required
Blue
Fast
blink Linux is running but it could not start
the firmware application N/A Download driver
Orange
slow
blink i-Vu® XT Router with drv_gen5 driver is
starting N/A No action required
Orange
2 blink i-Vu® XT Router with drv_gen5 driver
has started but is not yet able to
determine system and network status N/A No action required
To get a Module Status report
A Module Status report provides information about the router and verifies proper network communication with the
router. You can get this report:
•
In the i-Vu® application — Right-click the router on the navigation tree, then select Module Status .
•
In the controller setup interface through the Service Port — Click and select Modstat from the drop-down
list.
See
Appendix - Module Status field descriptions (page 43).