i-Vu® XT Router (drv_gen5)
CARRIER CORPORATION ©2022
Installation and Start-up Guide
18
All rights reserved
To wire to a BACnet MS/TP network
An MS/TP network can be wired to either
Port S1
or
Port S2
.
1
Turn
on
the i-Vu® XT Router's power.
2
Check the communications wiring for shorts and grounds.
3
Connect the communications wiring to the
Port S1
or
Port S2
screw terminals labeled
Net +
,
Net -
, and
Shield
.
NOTE
Use the same polarity throughout the network segment.
4
If you are using
Port S1
, and the controller has a
Port S1 Configuration
rotary switch, set it to 1.
NOTE
If
Port S1
is not being used for any network, set this rotary switch to 0.
5
If the i-Vu® XT Router router is at either end of a network segment, set the port's
End of Net?
switch to
Yes
.
NOTE
The router’s
End of Net
switch applies network termination and bias. See the
Open Controller Network
Wiring Guide.
6
Turn on the router's power.
7
To verify communication with the network, get a Module Status report in the i-Vu® interface for a router on
the MS/TP network.
NOTE
This step requires that you have discovered and uploaded the router in the i-Vu® application.
Содержание i-Vu XT
Страница 49: ......
Страница 50: ...Carrier 2022 Catalog No 11 808 826 01 1 11 2022...