Carrier i-Vu CIV-OR, Руководство по установке и запуску

Страница: 18 / 36

Installing the i-Vu® Open Router
i-Vu® Open Router CARRIER CORPORATION ©2020
Installation and Start-up Guide All rights reserved
14
Using PuTTY
1
Download and install PuTTY from the PuTTY website
( http://www.chiark.greenend.org.uk/~sgtatham/putty/download.html ).
2
Connect the laptop to the controller or sensor using the appropriate USB Link cable(s), as described above.
3
To change a router's IP address, subnet mask, or default gateway, set its IP Address DIP switch to Assigned .
4
Start PuTTY.
5
Under Category > Connection , select Serial .
6
Under Options controlling local serial lines , enter the following settings:
Field Value
Serial line to connect to Replace X with the computer's port number that the USB Link cable is
connected to.
NOTE To find the port number, select Start > Control Panel > System >
Device Manager > Ports (Com & LPT) . The COM port number is beside
Silicon Labs CP210x USB to UART Bridge .
Speed (baud) 115200
Data Bits 8
Stop Bits 1
Parity None
Flow Control None
7
Click Open . A window similar to the one below appears.
8
Do one of the following:
○
To change a property value:
a. Type the number of the property, then press
Enter .
b. Type the new value, then press Enter .
○
To take an action, type number of the action, then press Enter .
9
If you changed a value, type
1
, then press Enter to restart the controller.
10
Close PuTTY.