© 2021 Carrier
11
MOUNTING NXTSD512HD
Method
The NXTSD512HD requires a rectangular cutout and is secured using up to 12 retaining clips with
securing screws. Refer to the figure below for the layout of these clips. Note that it may not be necessary to
use all of the clips to achieve a proper fit.
NXTSD512HD showing placement of the retaining clips
The retaining clips accept an M4x0.7 threaded screw (40mm length
provided). The figure below shows the retaining clip. The clips first
latch into the perimeter of the screen from the rear using hooks. As
the screws are tightened, they push against the back of the panel. As
this happens, pressure is applied to the retaining clips to secure the
screen. Tighten the screws evenly and only to a sufficient pressure to
ensure that they remain in position. A medium strength thread-locking
compound (commonly referred to as “blue”) may be used to prevent
loosening of the screws if the equipment is subject to vibration or will
be in transit.
Post with knurled-head thumb nut
