Remote Controller
GB - 2
Mounting
waRNING:
Before installing the remote controller, turn off all power
to the unit that will supply power to the remote controller.
Electrical shock can cause personal injury or death.
General information and characteristics
IMPoRtaNt:
Read the entire instruction manual before starting the
installation.
• For trouble-free installation, which should be carried out by a
qualified installer, follow the installation chart sequence.
• Follow all current national safety code requirements.
• After installation thoroughly test the system operation and
explain all system functions to the owner.
• Leave this manual with the owner for consultation during future
periodic maintenance.
• Dispose of packaging material in accordance with local
requirements.
• The manufacturer denies any responsibility and warranty shall
be void if these installation instructions are not observed.
• Inspect equipment for damage due to improper transportation
or handling: file an immediate claim with the shipping company.
Do not install or use damaged units.
• In case of any malfunctioning turn the unit off, disconnect the
mains power supply and contact a qualified service engineer.
Models
Cooling only / heat pump
Products that the remote controller can interface with
30aw.
wiring
• The remote controller must be connected to the 30AW unit.
Power supply
Note that the remote controller requires no batteries.
The remote controller will not work without being connected to a
30AW unit.
Mounting screws
operating limits
The remote control is designed for indoor applications in
residential and/or commercial environments.
It is typically applied by fixing to the wall at a height accessible to
the operator, without any special limits usually required for analo
-
gue equipment with internal temperature sensors.
The operating limits are:
Maximum operating temperature
+50°C
Minimum operating temperature
+0°C
Maximum storage temperature
+70°C
Minimum storage temperature
-10°C
Maximum operating relative humidity
80% r.h.
Maximum storage relative humidity
95% r.h.
Nominal power supply voltage
12 V ac (+/- 10%)
Choosing the installation site and installation
Remote controller
• Turn OFF all power to unit.
NotE 1: configure the remote mode on the units 30aw.
128H97.indd 2
18-02-2010 16:29:53
Содержание Aquasnap Plus 33AW-RC1
Страница 27: ... GR 1 30AW 2 2 2 2 3 3 4 4 E mm 124 24 80 ...
Страница 28: ... GR 2 30AW 30AW 30AW 50 C 0 C 70 C 10 C 80 95 12 V ac 10 1 30AW REM ...
Страница 30: ... GR 4 30AW 1 2 3 6 7 8 6 7 8 1 2 3 LED 1 12V 1 30AW 2 1 3 12 Volt 1 12 30AW 12 Volt 1 ...
Страница 43: ......