2---1
SECTION 2
OPERATION
2.1 INSTALLATION OR REMOVAL
1
2
3
4
5
3
6
7
8
9
6
3
10
11
3
1. Refrigeration Unit
2. Engine Exhaust System
3. Tie Rods (Generator)
4. Engine (Location)
5. Generator Set
6. Fork Lift Pockets
7. Battery Charger Plug and Cable
(Optional)
8. Refrigeration Unit Power Plug
and Cable
9 Generator Electrical Connector
(Location)
10. Fuel Tank Sump
11. Fuel Tank (Location)
Figure 2---1. Unit Locational View
a. Installation
TIE ROD
ASSEMBLY
GENERA-
TOR
SET
REFRIGERA-
TION
UNIT
Partial end view of refrigeration unit and generator set
Figure 2---2. Generator Set Tie Rod
1. Make sure tie rods, Figure 2---2 and item 3,
Figure 2---1 are in position before installing genset. The
two upper tie rods must be in the up position and held in
order to secure generator set.
2. With fork lift pockets provided (item 6,
Figure 2---1), place genset in container.
3. Place tie rods in brackets provided (four on
genset) and secure same as shown in Figure 2---2.
4. Connect exhaust lines and muffler to genset
exhaust manifold.
5. Install refrigeration unit power plug in genset
power receptacle.
6. Install battery charger plug in receptacle at the
base of the generator control box (69GN15---114 only).
b. Removal
Reverse steps in paragraph a.
2.2 PRE---TRIP INSPECTION
a. Before Starting Generator Set
1. Check engine lubrication and fuel oil filter
cases, oil lines, and connections for leaks.
(Tighten connections and/or replace gaskets)
2. Check engine lubrication oil level.
(Refer to paragraph 1.4.j.)
3. Check engine V---belt for proper tension, fray-
ing or cracks. Adjust belt or replace.
(Refer to paragraph 4.5.)
4. Check radiator hoses for leaks and check
radiator coolant level. (Add pre---mixed 50/50 anti-
freeze---water as required.)
(Refer to paragraph 1.4.c.)
5. Check radiator coil and generator air intake
screen for cleanliness. (Clean using compressed air,
reversing the normal air flow.)
6. Check air cleaner for cleanliness and clean if
necessary. (Refer to paragraph 4.3.5.)
7. Drain water from fuel tank sump.
8. Fill fuel tank with diesel fuel.
(Refer to paragraph 1.4.g.)
9. Check glow plug amperage.
(Refer to paragraph 1.4.h.)
10. Check battery terminals for cleanliness and
securement. (Clean and coat with a mineral type grease.)
11. Check for loose electrical connections.