40MUAA: Installation Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
5
INSTALLATION REQUIREMENTS
Review the following information before installing the unit:
•
Do not
install the indoor units near a direct source of heat such as
direct sunlight or a heating appliance.
• Allow sufficient space for airflow and unit servicing. See Fig. 5 — on
page 6 for the minimum required distances between the unit and the
walls or ceilings.
• Communication wiring must be at least 3 ft. (1m) away from all
electromagnetic interference (televisions, radios, etc.) sources.
Interference is still possible even if this distance is maintained.
• Ensure any hanger used is strong enough to withstand the unit’s
weight.
• If the indoor unit is installed in an unconditioned space, running for
long periods of time when the temperatures are outside the
recommended indoor unit operation ranges, it is recommended that the
installer seal all corners of the indoor unit to prevent any leaks and add
insulation material (13/32 to 13/16 in (10-20 mm)) to the entire surface
of the indoor unit to avoid condensation or heat transfer.
NOTE: Nuisance sweating may occur if the unit is installed in a high
humidity environment with low airflow.
Table 3 — Operating Range
NOTE: DO NOT install the indoor or outdoor units in a location with
special environmental conditions. For those applications, contact
your Ductless representative
.
OPERATING RANGE (Min/Max °F (°C))
Cooling
Heating
Indoor DB
62 / 90 (17 / 32)
32 / 86 (0 / 30)
Indoor WB
59 / 84 (15 / 29)
N/A
PRODUCT INSTALLATION
• Installation must be performed by an authorized dealer or
specialist. A defective installation can cause water leakage,
electrical shock, or fire.
• The installation must be performed according to the installation
instructions. Improper installation can cause water leakage,
electrical shock, or fire. (In North America, installation must be
performed in accordance with the requirements of NEC or CEC
by authorized personnel only.)
• Contact an authorized service technician for repair or maintenance
of this unit. This appliance must be installed in accordance with
local codes.
• Only use the included accessories, parts, and specified parts for
installation. Using non-standard parts can cause water leakage,
electrical shock, fire, or unit failure.
• Install drainage piping according to the instructions in this manual
and in accordance with local codes. Improper drainage may cause
water damage to your home and property.
• For units that have an auxiliary electric heater installed, ensure 1"
of clearance from any combustible materials for first 3 feet (1
meter) of plenum and duct work exiting the unit.
•
DO NOT
install the unit in a location that may be exposed to
combustible gas leaks. If combustible gas accumulates around the
unit, it may cause a fire.
•
DO NOT
turn on the power until all work has been completed.
• When moving or relocating the system, consult experienced
service technicians for the disconnection and re-installation of the
WARNING
Securely install the indoor unit on a structure that can sustain its
weight. If the structure is too weak, the unit may fall and cause
personal injury, unit and property damage, or death.
DO NOT
install the indoor unit in a bathroom or laundry room as
excessive moisture can short the unit and corrode the wiring.
WARNING
Install the indoor and outdoor units, cables and wires at least 3.2 ft
(1m) from televisions, routers, computer equipment or radios to
prevent static or image distortion. Depending on the appliances, a
3.2 ft (1m) distance may not be sufficient.
If the indoor unit is installed on metal, it must be electrically
grounded.
CAUTION