Carpenter Model 59 Wire Prefeed & Dereeler
Carpenter Model 59 Wire Prefeed & Dereeler
•
Phone
: (315) 682-
9176 •
Fax
: (315) 682-9160
Website
: www.carpentermfg.com •
Revised 09/27/2021
Page 7
Section 1
–
Assembling the Model 59
The Model 59 is shipped partially disassembled to allow for save travel. Assembly of
the unit is very straightforward.
Follow the steps below to assemble the Model 59.
1. The PN 5269 dereeler stand assembly is shipped in its own box. Remove the
stand assembly from the shipping container. (This box may also contain [1] PN
8019 power input cord, the machine dereeler axel assembly, and any other
purchased spare parts. Remove these parts if necessary.)
2. Carefully remove the Model 59 from its shipping container and place it on a flat
surface. (If the box in Step 1 above did not include the mentioned loose items,
this box will. Remove these parts if necessary.)
3. Looking at the front of the Model 59, locate (4) PN 5429 button head screws and
(4) PN 7188 washers on the left side of the machine cabinet.
Using a 3/16” hex
wrench, remove these screws and washers. Refer to Figure 1 below.
