ULW Czech, s.r.o.
V Ráji 34, Praha 9
-
Hostavice, 198 00, CZ, IČO: 28256212, DIČ: CZ28256212
10.1.5.
When voltage level exceeds 13,1V, the power source will turn on within 30
seconds (soft start). Exceeding the operating voltage threshold will be indicated by
a stable green LED on the power source.
10.1.6.
Regardless the automated switching function of the power source, it is
recommended that you connect it to your vehicles auxiliary power outlet linked to
the ignition (the outlet is only powered, when ignition is ON).
10.1.7.
If the power source is connected directly to the vehicle’s battery or “always on”
auxiliary power outlet, the power source will turn on or will be caught in on/off
cycle when you connect your vehicle to a battery charger. This frequent ON/OFF
condition might cause premature power source failure. It is recommended that
you disconnect the power source from your vehicle especially in case you keep the
vehicle connected to a charger for extended periods of time (e.g. winter storage).
10.1.8.
Remove the Device from the Holder and disconnect the M8 charging cable from
the Device, when you charge you
r vehicle’s battery.
10.1.9.
NOTE: if you use LiFe battery in your vehicle and you connected the power source
directly to the battery or “always on” auxiliary power outlet
, the power source will
not turn off when engine is stopped, because LiFe batteries have higher nominal
voltage than standard led-acid batteries.
10.1.10.
The power source requires that the electrical system of your vehicle can handle a
stable power draw of at least 15W (approx. 1A at 14V).
10.1.11.
If your vehicle cannot provide the minimum voltage required for the power source
operation (13.1V), there is an alternative power source available as paid accessory,
which will engage at 10V
, but which will NOT provide a protection of the vehicle’s
battery against depletion in case you leave the Device charging in the Holder with
engine stopped. Even a single full charge of the Device with engine stopped (and
alternator not generating power) might deplete you
r vehicle’s battery so deeply
that you will not be able to start the engine.
10.1.12.
The power source includes reverse polarity and over-heating protection. It will
only provide overvoltage protection up to 20VDC on input (maximum voltage
rating). Exceeding the maximum voltage rating will destroy the power source and,
as a consequence, might also destroy the Device.
10.1.13.
When installing the power source on your motor vehicle, make sure to connect the
leads on the input in the correct polarity. The input leads are equipped with
6,3mm faston tab. Some motorcycles have the corresponding female sockets on
their auxiliary power outlets. you can also connect the power source directly to the
battery, but you will need to use cable extender
with a fuse
(5A fuse is
recommended).
NEVER connect the power source directly to the vehicle battery
without implementing a fuse
. When you connect the battery to your vehicle
auxiliary power outlets, those should already be equipped with a fuse (check your
vehicle specifications to verify this).
10.1.14.
Battery extension cable with 5A fuse box and M6 loops that mates with our power
source is available as optional accessory):
