Caro VISION II, Руководство по эксплуатации

Страница: 10 / 33

8
Automatic satellite search
After switching on the system by pressing , the antenna opens and
moves into the position in which a satellite was last received. If not
satellite is found, the system starts the fully automated search for the
preset satellite (default setting: Astra 1). If you wish to change the preset
search satellite, please refer to section "Settings" on page 12.
When the search satellite is found, the search function stops and the TV
signal is looped through. If no TV picture appears after an extended
search (several minutes), you are most likely located in an area in which
the preset satellite cannot be received or the signal beam is obstructed. In
this case, the message "not found?" appears in the display of the control
panel. Then another search satellite should be selected or the obstacle be
removed or the vehicle position be changed, if required.
The automatic search function always assumes that your vehicle is
perfectly level. If this is not the case the search time may be extended.
If the antenna is already open, the automatic search function is started as
follows:
-
Press until the message "Automat. search" appears in the display.
-
Press .
If the receiver is not switched on at the end of the automatic search, a
message will appear in the display.