4
www.CarnivalKingSupplies.com
.
||||| [email protected]
BLOCK Ice Shaver Machine Manual
Operation
Recommended: for the fluffiest, snow-like ice, temper ice to room temperature for at least 20 minutes. To release ice block
from mold, pour warm water over the outside of the mold. Tempering the ice too quickly may result in cracked ice, which
should not be used.
1. Please ensure that the machine is on a level stable surface, the feet are intact and level.
2. Open the block shaver safety-shield, and wipe the shaving plate with a dry cloth, check that the blade is firmly installed.
Please use cation to avoid the exposed blade
3. If using the foot pedal, install the foot pedal by plugging it into the back of the machine.
a. WARNING: do not leave foot switch accessible to inadvertent operation when left unattended or when not
being used.
4. Place an ice block no bigger than 7” x 7” on the shaving plate, do not overfill.
a. WARNING: ensure the block is centered, using the concentric guidelines. Uncentered blocks may dislodge
from ice claw.
b. Allow ice block to temper (To "temper" is to "warm up" your ice blocks in order to get the correct ice consistency.
Tempering allows the ice to reach the ideal shaving temperature of 18 to 20 degrees Fahrenheit. Once the ice block
begins to melt (or sweat), it is an indication that the ice has reached the tempered stage.) for at least 20 minutes for
finer and fluffier texture. We recommend not using ice blocks straight from the freezer.
5. Adjust the ice claw to secure the ice block by rotating the handle clockwise (or counterclockwise to loosen). Ensure the ice
claw teeth penetrate the ice block. Release the handle after ice block is centered and secure.
b. WARNING: do not touch the teeth of the ice claw.
6. Close the safety-shield and place a cup, bowl, or tub directly below the ice chute. Turn the Main Power Switch ON or press
down on the Foot Switch. To stop shaving ice, release Foot Switch.
a. WARNING: KEEP SAFETY-SHIELD CLOSED AT ALL TIMES WHEN OPERATING MACHINE.
7. Keep an eye on your block ice and replace block when there is 1/4" left or at your own discretion. Warning: do not let ice
claw touch the shaving plate while operating. TURN the front switch to turn OFF or take your foot off the pedal.
a. Note: Note: when replacing the block ice - make sure to switch OFF power and remove foot from pedal. This machine
can still operate with safety-shield open.
8. To adjust the ice texture, turn the Blade Adjustment Knob CLOCKWISE for a finer ice texture, COUNTERCLOCKWISE for a
coarser ice texture.
9. Top with Carnival King Sno-Cone Syrup, condensed milk, frozen or fresh fruit, or marshmallow fluff!
Warning
ELECTRIC SHOCK HAZARD
Keep water and other liquids from entering the inside of the equipment. Liquid inside the equipment could cause an
electrical shock.
Warning
Sharp blades, do not place hands in or near the ice holder while the motor is running.
COARSE
FINE
SHAVING TEXTURE
7"
4"
4"
7"
7"
4 lbs.
Minimum
Shaving
Plate
10 lbs.
Maximum
