Carlton Hurricane RS, Руководство пользователя, Страница: 117 / 153

I & M BULLETIN
HPTO8TD-100
HYDRAULIC POWER TAKE-OFF
Page 7 of 7
Endcover Sub-assembly
ATTENTION: Check for burrs or debris
in bore of endcover at oil inlet and
outlet holes.
1. Pack bearing (Item 13) on shaft with
MOBILITH SHC 220 grease only to
20% capacity on outer bearing race.
2.
Pack end of endcover with the
retaining ring with MOBILITH SHC
220 grease only to 20% capacity on
outer diameter. See figure 2 for
location where grease should be
packed during this step.
3. Lower end cover down over the shaft
and hook piston rings. ATTENTION:
insure that hooked piston rings
lead into the end cover with out
binding. Insure that seal lip does
not roll back during shaft
installation
.
4. Pack end of endcover with MOBILITH
SHC 220 grease only . Pack to 20%
capacity on outer diameter. See
sketch above for location where
grease should be packed during this
step.
5. Pack bearing (Item 13) MOBILITH
SHC 220 grease only to 20%
capacity on the outer bearing race.
Note: Bearing (Item 27) should have a
shoulder on one side and no grease
from factory. Using bearing press
fixture install bearing and fixture over
threaded rod and drawing bearing
onto shaft using a hex nut on the
threaded rod. Bearing will stop
against shaft shoulder.
Important:
Install bearing with shoulder to
outboard side (refer to drawing).
Support housing to allow bearing to
be pressed all the way down. Lightly
tap on shaft until retaining ring groove
is fully visible.
6. Lightly lube ID and OD of bearing with
Mobilifluid 424 or similar oil. Thread
½-13 rod into shaft. Use a bearing
press fixture that contacts the inner
bearing race. Install bearing and
fixture over threaded rod.
7. Draw bearing onto shaft using a hex
nut on the threaded rod. Bearing will
stop against retaining ring.
8. Insert key (Item 36) into keyway of
shaft end.
9.
Important: Remove spring from
seal
and install seal (Item 28) lip
facing out. Refer to drawing for
proper orientation.
Attention: do not
over press.