Your toaster should be used in such a way
that it is protected from moisture. e.g.
condensation, splashed water etc. Do not
place or store your toaster where it can fall
or be pulled into water or any other liquid.
Do not reach for the appliance if it has
fallen in any water or any other liquid.
Unplug immediately.
Stand your toaster on a stable, level surface
during use. Do not allow your toaster to sit
on top of the mains lead.
Bread may burn. Your toaster must not be
used near or below curtains or other
combustible materials. It must be watched
when in use. Do not leave your toaster
unattended, bread may jam in the toast
slot.Your toaster should be placed away
from heat sources such as radiators,
gas/electric fires and direct sunlight. Keep
the power cord away from any heated
surfaces. Use the appliance only for its
intended use, as described in this manual.
Do not use outdoors.
Information and advice
Safety first!
Your toaster is supplied with an approved 13 amp fused mains plug. When replacing the fuse always use a 10 amp
(BS 1362)
approved type. If the mains sockets in your home differ or are not suitable for the type of plug supplied, then the plug should be
removed and a suitable type fitted.
Please refer to the wiring instructions at the back of this book.
C
O
M
P
L E T E W
I
T
H
F
I
T
T
E D
P L
U
G
Only toast bread in your toaster, do not
attempt to toast any pastry or bread product
which is filled with a fruit or sugary filling
(pop tarts etc). The contents may leak from the
product and cause damage to your toaster
with the possible risk of a fire occurring.
Make sure that children cannot touch the
toaster when hot or pull the mains lead.
It is DANGEROUS to insert fingers or objects
other than bread into the toast slot. Never
place your fingers or metal objects in the
toast slot. Do not allow young children to
play with your toaster.
Never use your toaster if it is damaged in any
way. Do not remove any fixed covers. Never
use this appliance if it is not working properly,
or if it has been dropped or damaged. If the
supply cord is damaged it must be replaced
by the manufacturer or its service agent or a
similar qualified person in order to avoid a
hazard.
Carlton CT1400.qxd 18/01/01 10:38 Page 3
